All Sun EM276 Injector Tester
This tester is designed to not-destructively measure the thickness of non-magnetic coatings (including paint enamel ,plastic ,epoxy, etc) on iron ,steel or Aluminum.
All-Sun EM2271 Professional Injector Tester Fuel Injector 4 Pluse Modes Tester Powerful Fuel System Scan Tool is a one of our All Sun EM276 Injector Tester Tools, you can buy All-Sun EM2271 Professional Injector Tester Fuel Injector 4 Pluse Modes Tester Powerful Fuel System Scan Tool from foxwellpro.com.
Wholesale Top quality VAS6154, GM Tech2, VCM II For Ford, Handy Baby II Car Key Chip Copier, CDP DS150
images of All-Sun EM2271 Professional Injector Tester Fuel Injector 4 Pluse Modes Tester Powerful Fuel System Scan Tool
Warning!!!
1.Battery insided already,please remember to take off the insulate strip.
2.Please don't use this device under 0 degrees Celsius !
3.The device is not available in measuring metallic paint on car or similar objects.
4.This tester may not be used to test your home appliances(refrigerator,oven,microwave oven,etc)
5.For measurements in AUTO test mode and on object with steel substrate
±(10% of reading + 0.10mm),
most car is made of steel, and, if you get result of 0.00mm or 0.01mm , it is under normal
condition,acceptable error, because most car paint thickness is 0.1-0.15mm.
6. There is not calibration plates in the parcel of EM2271. It doesn't need calibration.
If you need, please contact us.
7 . Please press the probe vertical to the object, and make sure the object surface is smooth and clean.
EM2271 Specifications:
• Measurement range: 0.0 to 2.0 mm, 0 mil to 80 mil
• Accuracy: 2%rdg +-0.1 mm, or 2%rdg+-4 mil
• Resolution:0.1 mm/1 mil
• Power supply: 1 x 3 V button cell, CR2032 or equivalent,
• Measuring technology: Magnetic
• Size :6.9 x 3.8 x 2 cm
• Weight: About 23 grams (including button cell)
How the device work
1. Probe
Before measurement, place the tester with its probe firmly against target surface.
Before measurement, place the tester with its probe firmly against target surface.
2. Display
3. "TEST" button
（1）. Press "TEST" button to turn on the tester. Press and hold down this button for about 1 second to turn off the tester.
（2）. Press "TEST" button to delete the reading on the display,the display will show "- -".
4. "UNIT" button
Press this "UNIT" button to select desired unit: mm or mil
EM2271A
The upgrated EM2271.
It can measure the Fe & NFe.
Accuracy improved 10, measurement range extended,
resolution higher, better cost-efficiency.
For measurements in AUTO test mode and on object with steel substrate
±(10% of reading + 0.10mm),
most car is made of steel, and, if you get result of 0.00mm or 0.01mm , it is under normal
condition,accpetable error, because most car paint thickness is 0.1-0.15mm.
