N2 Throttle Booster 6-Drive for All BMW 2000-2015

N2 Throttle Booster 6-Drive for All BMW 2000-2015

Product Function and Features:

The acceleration levels are changed in smooth curve (see the illustration) without increasing the difficulty of accelerator operation.
For better understanding of shift-gear regulation, we make a distinction between automatic and manual transmission mode. The acceleration sense of manual mode is stronger than the automatic one at same level. However you can also make flexible operation in practical situation according to you own driving habits.

This device suitable for All BMW from 2000 to 2015, including 1series, 2series, 3series, 5series, 7series(not support MINI Cooper)

Attention:

1. The products’ default setting will be manual full acceleration.
2. We have to remind you of safe driving though this product can be used to change modes and levels at any time.

Product Installation:

1. Install the throttle connector of this product between the accelerator pedal and the car;
2. Stick the display controller on the place which is easy to adjust.
3. Connect well the cable between the throttle connector and display controller. If the cable is too long, it can be belted on appropriate position.

Safety Precaution:

1 Before installation, you need to recognize all the plugs and socket's direction (NOTE: you can tell socket's directions by the outlet location
on throttle connector, the direction of the accelerator pedal and the form of plug-in connection, etc.) and make sure the plug connection is stable.
2 After installation, you are supposed to start the car in neutral or P gear and confirm accelerator pedal available.
3 The wrong direction in installation will lead to unavailable accelerator pedal and engine fault light on. Please be calm.
There is protection circuit inside the product to protect the vehicle original components. You should turn off the engine
immediately and remove the product, and wait for at least two minutes (to let the protective circuit to resume normal work).
Then install the product in right direction will be OK. (At this time engine fault light still on, you are advised to consult agents for solution.)

Operation:

1 The device can be used via three buttons on the display controller (“Mode”, “-”, “+”buttons).
2 It can be adjusted at any time after power on but attention please.
3 Press the M (Mode) button and the acceleration mode on the controller will displayed in a regular cycle:
full hand acceleration-> full automatic acceleration-> half hand acceleration-> half automatic acceleration-> original accelerator mode-> economic mode.
4 The “+” and “-”buttons are used for degree adjustment in the unified mode (e.g. gradually get stronger from 1-9);
there are 9 degrees for adjustment except the original accelerator mode.
5 The display component is combined with nixie tubes in shape of 3-8 letters. Letter “F” means full acceleration;
Letter “H” means half acceleration; the second Letter “H” means the hand-shift status; Letter “A “means the automatic status.
Please refer the the picture below:

Full Hand Acceleration Mode: